After scanning approximately *100,000 pages through the ADF, the ADF Friction Roller may be worn out and you may experience problems with document feeding. In this case, you may need to replace a new ADF roller. For ordering the ADF roller, please consult your nearest dealer and follow the procedure below to replace it.
Replacing the ADF Friction Roller
Dissembling Procedure
- Open the panel unit by pulling the panel unit open lever.
- Gently open the ADF Front Door to the left.
- Press the right end of the Friction Roller externally to detach it from the slot and then detach the left end from its hole.
Reassembling Procedure
1. Insert the left end of the Friction Roller to the hole of its original place. Make sure the flat side is up as shown.
2. Insert the right end of the Friction Roller to its slot.
3. Close the ADF Front Cover.
Replacing the ADF Roller
After scanning approximately *200,000 pages through the ADF, the ADF roller may be worn out and you may experience problems with document feeding. In this case, you may need to replace a new ADF roller. For ordering the ADF roller, please consult your nearest dealer and follow the procedure below to replace it.
Dissembling Procedure
1. Gently open the ADF front cover.
2. Use both hands to pull the roller cover to open it.
3. Move the tab of the ADF roller UP as indicated.
4. Detach the right end of the ADF roller from the scanner and remove the ADF roller.
Reassembling Procedure
3. Close the ADF roller cover. A snap-in sound could be heard if correctly installed.